Precautions before installation of the reducer: The installation shaft of the machine should be cleaned before use.And check whether the installation shaft has any bruises and dirt, and if there are any, they should be cleaned up.The operating temperature of the reducer is 0-40°C.Check whether the matching size of the hole connected with the reducer meets the requirements, and the tolerance of the hole should be H7.Before use, the blockage at the high position should be replaced with an exhaust screw plug to ensure that the gas in the body is discharged when the reducer is running.
The installation of the reducer, the reducer can only be installed on a flat, shock-absorbing, torsion-resistant support structure.Under no circumstances is it allowed to hammer pulleys, couplings, pinions or sprockets, etc. into the output shaft, as this will damage the bearings and shaft.Operation and maintenance, after the reducer is installed, check whether it is flexible.For official use, please carry out no-load test. Under the condition of normal operation, gradually load the operation.It is strictly forbidden to use the reducer beyond the rated load.The reducer should check whether the oil level is normal before use and during operation. The machine has been filled with lubricating oil before leaving the factory.Principles of oil change: Change the oil at the beginning, the lubricating oil should be replaced after the machine has been running for 300-400 hours, and the lubricating oil should be replaced every 1500-2000 hours thereafter.In the workplace with harsh working environment, high temperature and large dust, the lubricating oil should be checked every half a month. If there is dirt in the lubricating oil, replace the lubricating oil to keep the lubricating oil clean and prolong the service life of the reducer. ,Improve economic efficiency.When changing the oil, wait until the reducer cools down and there is no risk of burning, but it should still be kept warm, because after complete cooling, the viscosity of the oil will increase and it will be difficult to drain the oil.
With the rapid development of my country's industry, reducers have promoted the increase in demand for reducers. Originally, many companies used imported reducers, but imported reducers are far from meeting the needs of reducers in my country. Imported reducers are expensive. The long delivery period of planetary reducers has become a prohibitive obstacle for merchants, which has also promoted the rapid growth of domestic reducers in recent years.
