Cycloidal pinwheel reducer conditions

1. The cycloidal pinwheel reducer is allowed to be used in the continuous working system, while allowing both forward and reverse directions.
 
2. The rated speed of the input shaft is 1500 rpm. When the input power is greater than 18.5 kW, it is recommended to use a 6-pole motor with 960 rpm.
 
3. The working position of the horizontally mounted cycloid reducer is horizontal. The maximum horizontal tilt angle during installation is typically less than 15°. Other measures should be taken to ensure adequate lubrication and prevent oil leakage when it exceeds 15°.

4. The output shaft of the cycloid reducer cannot be subjected to large axial and radial forces. Other measures must be taken when there are large axial and radial forces.