Teach you how to install planetary reducer correctly

As a super functional and cost-effective reducer, it has a wide range of uses in industry. Today, I will tell you how to correctly install the planetary reducer. I hope it will help you.

Step 1 of installation: first confirm whether the motor and reducer are intact, and seriously check whether the specifications of all parts connected with the drive motor and reducer are matched. It refers to the specification and cooperative service between the positioning boss and shaft diameter of the drive motor flange and the positioning groove and hole diameter of the reducer flange, and the dirt and burr on the cooperative surface shall be wiped.

Step 2 of installation: unscrew the screw plug on the technical hole around the reducer flange, rotate the input end of the reducer, align the locking hexagon socket screw cap with the technical hole, insert the hexagon socket and loosen the locking hexagon socket screw.

Step 3: hold the drive motor by hand, make the keyway on the shaft and the locking screw of the input end hole of the reducer straight, and pierce the drive motor shaft into the input end hole of the reducer. When piercing, ensure that the concentricity of both sides is parallel to the flanges on both sides. It is necessary to find out the cause if the concentricity is different or the flanges on both sides are not parallel. In addition, it is strictly prohibited to hammer the equipment, that is, it can prevent the axial force or radial force of the hammer from damaging the bearings of the two, and it can also distinguish whether the cooperation of the two is suitable through the feel of the equipment. The method to distinguish the concentricity of the two cooperation and the parallelism of the flanges is: after the two are inserted into each other, the flanges of the two are closely connected and the gap is the same.