What are the maintenance methods for hard tooth surface gear reducer parts?

The hard-tooth surface gear reducer should be regularly cleaned of oil stains and dust to keep it clean, which is beneficial to heat dissipation.If the reducer frame seal is damaged, it should be replaced immediately.The reducer should frequently check the remaining oil and make up for the remaining oil shortage in time.At the same time, the parts of the hard journal reducer require more maintenance.Below, the maintenance methods of its parts will be introduced in detail.

The components of the hard tooth surface gear reducer are the most important components of the reducer.Once a component fails, it may affect the operating power of the reducer.In order to ensure the normal operation of the reducer, we should pay sufficient attention to the overall design of the gears, shafts, bearing components and casing, and perform corresponding maintenance work.Regularly check the direction of the grease housing to see if the height is sufficient.If not, add grease immediately.Items that exceed the standard limits cannot be brought into the operation process.

The exhaust fan is installed on the top of the case of the hard tooth surface gear reducer.During the operation of the reducer, the temperature inside the box rises, the gas expands, and the pressure increases.In order to enable the thermally deformed air energy water heater in the box to be discharged freely, the pressure inside and outside the box should be balanced, and the grease will not leak along other gaps such as the surface of the double-door box or the sealing area of ​​the shaft extension.When adding an oil plug and changing the oil, waste fluid and detergent should be drained out.The oil inlet should be opened at the bottom of the car's fuel tank seat and under the oil pool.The oil inlet should be plugged with a cork.Add a leak-proof gasket between the fusion surface of the oil plug and the storage tank.The oil level indicator should check the oil level of the reducer oil sump and maintain proper oil in the oil sump at all times.The oil level indicator should generally be installed in a part of the box where it is easy to observe and where the oil level is stable.Every time you disassemble or install the car cover, be sure to maintain the accuracy of the seated bearing hole.Before making the bearing holes, the connecting flange between the machine cover and the box seat should be equipped with positioning pins.The bearing cap fixes the radial position of the shaft system components and bears the radial load. Both sides of the bearing hole with a seat are closed with bearing caps.At the same time, the hard tooth surface gear reducer is a driving force transmission mechanism that converts the motor speed into the required speed according to the internal structure, and at the same time outputs a large torque.

During the operation of the hard tooth surface gear reducer, attention should be paid to its temperature.When using component oil, the temperature should not be higher than 100 degrees, and when using mineral oil, the temperature should not be higher than 95 degrees.After the reducer is installed, a full load test must be carried out first.If everything runs normally and there are no inconveniences, the hard-tooth surface reducer can be loaded and run slowly.