How to prevent overload of WPS50-50-A worm gear reducer
Publish Time: 2026-01-06 Origin: Site
The key to preventing overload of the WPS50-0-A reducer is to work together in four aspects: Specific measures are as follows:material optimization, lubrication upgrade, load control and regular maintenance .
1. Materials and design optimization
Worm Strengthening : Use 40Cr alloy steel and quench to HRC45-55 to improve the wear resistance of the tooth surface.
Worm gear adaptation : Made of tin bronze (ZCuSn10Pb1), hardness HB80-120, forming a 'hard + soft' pairing with the worm to reduce adhesive wear.
Parameter adjustment : Increase the worm gear displacement coefficient, increase tooth thickness and contact area, and reduce single tooth load.
2. Lubrication system upgrade
Oil product selection :
Ordinary working conditions: ISO VG 320/460 mineral oil or special oil for worm gears.
Heavy-duty working conditions: synthetic lubricating oil (such as PAO), high temperature resistance (flash point ≥ 240°C).
Forced lubrication : When the speed is >1500r/min, the oil pump is used to circulate oil, and the cooler is used to control the oil temperature to ≤70°C.
Regular oil change : Change the oil for the first time after the new machine has been running for 500 hours, and then every 2000-3000 hours or every year.
3. Load and operation control
Overload protection :
Install a torque limiter (set value is 1.2~1.5 times the rated torque) to prevent slipping and disengagement in case of sudden overload.
Install an elastic coupling (such as a serpentine spring coupling) between the motor and the reducer to buffer the startup impact.
Soft start optimization : Use a soft starter (starting time ≥10s) to avoid motor starting current shock.
Temperature monitoring : When the ambient temperature is >40℃, install a cooling fan or water cooling device to ensure that the shell temperature is ≤90℃.
4. Maintenance and monitoring
Periodic inspection :
Stop the machine every 5,000 hours to check the meshing clearance (allowable deviation ±10% of the design value), and adjust the gasket or gear shaft position if it is out of tolerance.
Oil samples are taken every 2000 hours for ferrography analysis to monitor the abrasive particle concentration.
Non-destructive testing : Conduct magnetic particle testing on gears every 1 to 2 years, focusing on testing the tooth root transition zone.
Operating specifications : It is prohibited to start with load and unload before stopping; operators need to be trained to use a stethoscope to judge abnormal noise.
Through the above measures, the risk of overload of the WPS50-50-A reducer can be significantly reduced and the life of the equipment can be extended.