How to check the oil level of XWDY7-23-11 cycloid pin wheel reducer

To check the oil level of the XWDY7-23-11 cycloid pin wheel reducer, you can follow the following steps:

1. Cut off the power supply : Turn off the input power of the reducer and make sure that the power supply will not be turned on accidentally during the inspection to prevent the risk of electric shock. At the same time, wait for the reducer to cool down to avoid burns.

2. Find the oil level screw plug : Refer to the reducer installation instructions or search on the reducer housing to find the oil level screw plug. Its position is usually determined by the installation position of the reducer, generally on the side or top of the reducer housing.

3. Remove the oil level screw plug : Use appropriate tools, such as wrench, carefully unscrew the oil level screw plug.

4. Check the oil level : Observe the oil level and check whether the oil is filled to the appropriate position. For some reducers with dipsticks, insert the dipstick into the oil level hole and then remove to see where the oil is on the dipstick to determine if the oil level is normal. If the oil level is too low, you need to add appropriate reducer oil until it reaches normal level; if the oil level is too high, you need to drain oil appropriately.

5. Install the oil level screw plug : After checking the oil level, make sure that the oil level screw plug and the surroundings of the screw holes are clean, then reinstall and tighten the oil level screw plug to prevent oil leakage.