What specific harms will loose screws bring to the operation of ZLY630-14-2 hard tooth surface reducer

Causes components to be displaced or fall off: loose screws connecting key components such as the reducer chassis, gear shaft, bearing seat, etc. will cause the relative position of these components to change, affecting the normal meshing of the gears and the positioning of the bearings. In severe cases, the components may fall off, causing the reducer to stop or even cause safety accidents.

Causes vibration and noise increase: loose screws will reduce the overall structural stiffness of the reducer, which is prone to vibration during operation. This vibration will further stimulate vibrations of gears, bearings and other components, resulting in increased noise. Vibration and noise not only affect the working environment, but may also mask other potential fault signals.

Causes seal failure and oil leakage: loose screws on the joint surface of the reducer, oil plug, breathable cap and other parts, will damage the sealing performance and cause lubricating oil to leak out. Oil leakage will cause the oil level in the reducer to drop, affect the lubrication effect, accelerate wear of gears and bearings, and also contaminate the workplace.

Accelerate part wear: Loose screws will make the connection between the relevant components no longer tight, and during the power transmission, these components will experience slight relative movement, resulting in friction and wear. In the long run, it will lead to wear of gear teeth, bearing damage, journal wear and other problems, shortening the service life of the reducer.

Influence transmission efficiency: The displacement and vibration of the components will reduce the meshing accuracy between the gears, and energy loss will occur when transmitting power, resulting in a decrease in the transmission efficiency of the reducer. This will not only increase energy consumption, but may also affect the performance of the entire production system.

Cause safety accidents: If the screws are loose, causing important components to fall off or the reducer to have serious failure, it may pose a threat to the safety of the operator, such as being involved in rotating parts, being damaged by falling parts, etc.