What are the quick solutions to oil leakage at the seal of BLEY5527-289-15KW cycloid pin wheel reducer
Publish Time: 2025-09-24 Origin: Site
BLEY5527-289-15KW oil leakage at the seal of the cycloid pin wheel reducer can be quickly solved by the following methods:
Use sealant or leak plugging agent : If it is a slight oil leakage, apply an appropriate amount of high-temperature resistant sealant to the sealing surface or bolt connection to enhance the sealing effect. Special lubricant leak plugging agent can also be added. This additive can form a temporary sealing film at the oil leakage point, which plays an emergency leak plugging role.
Adjust the oil level : Check the oil level of the reducer. If the oil level is too high, excess lubricating oil must be released through the oil drain hole to keep the oil level at the center line of the oil standard to reduce oil leakage caused by excessive oil level.
Clean the vent holes : Blockage of the vent holes will increase the pressure inside the reducer, causing oil to seep out of the seal. Therefore, the ventilation holes should be cleaned in time to ensure that they are unobstructed, so that the internal pressure of the reducer is balanced with the external pressure.
Tightening bolts : Check whether the bolts at the seal are loose. If they are loose, tighten the bolts evenly in multiple diagonal orders to ensure that the sealing surface is tightly fit and prevent oil leakage.
Repair shaft seal : If the shaft seal is worn and causes oil leakage, fine sandpaper can be used to polish the shaft surface to reduce roughness, and apply a small amount of grease for temporary repair.