Why do planets slow down with the possibility of breaking their axis.The biggest possible problem with the fracture is the mass of the planetary reducer.Of course, this is something we can think of in ordinary times, mainly because it is generated during ordinary use.For example, how should we focus and what is a good way to accelerate and decelerate with the planet reducer.Here's a summary of three reasons for a simplifier.
1. This principle must be strictly observed in certain applications.This is not only to protect the reducer, but also to prevent the output shaft of the planetary reducer from twisting.This is mainly because if there is a problem with the installation of the equipment, the output shaft of the reduction and its load will be stuck.At present, the overload capacity of the driving motor will still make it continuously increase its output. In addition, the output shaft of the reducer may be subjected to more than twice its rated output torque, and the output shaft of the reducer may be broken.
2. During acceleration and deceleration, if the instantaneous torque multiplied by the speed of the output shaft of the planetary reducer exceeds 2 times its rated output torque, and the acceleration and deceleration are too frequent, the reducer will eventually be broken.Given the rarity of this condition, it will not be described further here.
3. Wrong type selection leads to insufficient reducer output.Some users mistakenly believe that as long as the rated output torque of the selected planetary reducer meets the working requirements, it is not.First, the value obtained by multiplying the rated output torque of the matching motor by the reduction ratio is in principle smaller than the rated output torque of a similar reducer provided by the product sample.Secondly, the overload capacity of the driving motor and the maximum working torque required in practice should be considered.Theoretically speaking, the user needs the maximum working torque.It must be less than 2 times the rated output torque of the reducer.
Among them, when using the planetary reducer, we must pay attention to its code of conduct, and at the same time, there are fatal reasons for the lack of wrong choices.When the output of the reducer is too small, the problem of shaft breakage occurs.Cracked shafts on planetary reducers are a common problem.In addition to damage to the reduction shaft due to poor concentricity of the components at the output of the reducer.The above three points are possible causes and problems.
